Giants Editor object repositioning tool

chaseydog
Posts: 466
Joined: Sun Sep 28, 2014 6:32 pm

Giants Editor object repositioning tool

Post by chaseydog » Tue Apr 19, 2016 1:16 pm

Is there anyway to adjust the location of the object repositioning tool (the red, blue, yellow arrow axis that appears when you select an object). Normally the tool shows up relatively close to the object, sometimes however the tool is so faraway from the object that it's difficult to position the object correctly. I'm building a new map using one of the starter maps. When I select the log pond water plane the white box reprinting the object shows up on one side of the map but the repositioning tool is on the other side of the map.
Nagce Valley map development www.chaseydog.net

chaseydog
Posts: 466
Joined: Sun Sep 28, 2014 6:32 pm

Re: Giants Editor object repositioning tool

Post by chaseydog » Tue Apr 19, 2016 3:02 pm

Sorry for the cross post. I'd intended to post this in FS15.
Nagce Valley map development www.chaseydog.net

Post Reply