hello.
I have a self propelled baler that have to smal pickup with for my straw swath. I have tried to change the with of the pickup width in Giants Editor and it did not work.
can someone please write step by step on how to change the pickup width of the baler(it would be nice with picutes)?
Change pickup width of a self propeled baler
3 posts
Page 1 of 1
-
- Posts: 5
- Joined: Wed Feb 21, 2018 9:15 pm
-
- Posts: 259
- Joined: Tue Nov 15, 2011 10:34 pm
Re: Change pickup width of a self propeled baler
Did you extract it from the zip file first?
1) extract the baler zip file.
2) open the i3d in Giants editor
3) look for startIndex, widthIndex, heightIndex
4)adjust startIndex and widthIndex - move them outwards from each other to make a wider pickup area.
5) Also move the heightIndex out the same amount as startIndex (so that x coordinates match).
6) save
7)try the mod in the game before zipping it back up, to make sure it has worked. BUT DON'T FORGET, if the original zip file is still in the mods folder, the game will use that first and it will look like your changes have not worked, so take the original zip file out and put it somewhere safe, (eg on your desktop) in case you need to revert to it.
1) extract the baler zip file.
2) open the i3d in Giants editor
3) look for startIndex, widthIndex, heightIndex
4)adjust startIndex and widthIndex - move them outwards from each other to make a wider pickup area.
5) Also move the heightIndex out the same amount as startIndex (so that x coordinates match).
6) save
7)try the mod in the game before zipping it back up, to make sure it has worked. BUT DON'T FORGET, if the original zip file is still in the mods folder, the game will use that first and it will look like your changes have not worked, so take the original zip file out and put it somewhere safe, (eg on your desktop) in case you need to revert to it.
-
- Posts: 5
- Joined: Wed Feb 21, 2018 9:15 pm
Re: Change pickup width of a self propeled baler
I have done all of that, but it dont work.
3 posts
Page 1 of 1