Hi, I've just downloaded a John Deere 8R series tractor that I'm pulling a chisel plow with. The only problem is that the rear hitch won't raise the plow high enough to get above the ground. What I need is a large pipe wrench to shorten the lift links but since that really isn't practical can someone tell me what would be the best way to adjust the i3d model to make the hitch raise higher? Would it be the rotpart or would it be the ref that I would need to adjust?
Thanks Mark
Plow won't raise high enough
4 posts
Page 1 of 1
Re: Plow won't raise high enough
Change the Attacher height in the xml (not i3d) for the plow or the tractor.
Re: Plow won't raise high enough
Thanks for the reply Dogface. Is that in the input atttacher joints section or the Schema overlay section?
Thanks
Mark
Thanks
Mark
4 posts
Page 1 of 1