As stated above I noticed that implements are a bit high when attached to the rear arm. The rear trailer attachment point is fine. This is for the Fendt 1000 found on modhub.
This leads to the question that if I want to fix it for myself, what do you think the issue is? There are only 2 areas. The attacherJoint section or the hydraulics section. The models by Giants are simplified in this area since there are no individual parts in this area.
Edward K.
Rear hydraulic arm a bit high on Fendt 1000
2 posts
Page 1 of 1
Re: Rear hydraulic arm a bit high on Fendt 1000
It looks as if the solution is in the XML file.
2 posts
Page 1 of 1