Bourgault 3420-100 Paralink Hoe Drill Issue
6 posts
Page 1 of 1
-
- Posts: 8
- Joined: Wed Apr 20, 2022 11:51 pm
Bourgault 3420-100 Paralink Hoe Drill Issue
On the Bourgault 3420-100 Paralink Hoe Drill when using courseplay or guidance steering it says the width is 8.5 rather than 30.5. I have tried this using different tractors and verified it using the 3320 which works properly. Something in the programming of this mod is not correct. The air cart is 8.5, but I have tried it without the air cart not even bought yet, so that is not the issue. Currently I have to tap my mouse to get it up to 30.5, which is a pain as it only goes up by 0.1 for each click. Love using it though.
-
- Posts: 594
- Joined: Mon Jun 20, 2016 5:23 pm
- Location: Canada
Re: Bourgault 3420-100 Paralink Hoe Drill Issue
Thats not the only piece of equipment that has a problem. The Case IH 3020 TerraFlex 25FT and the New Holland SuperFlex 25FT show up in guidance steering as 8.2 despite being 7.5. Its worse though. The AI treats them as 8.2 even thought they actually cut 7.5.
As for guidance steering: you can change the increment from 0.1 to 0.5 or 1.0 or possibly more using the controls built into the interface.
As for guidance steering: you can change the increment from 0.1 to 0.5 or 1.0 or possibly more using the controls built into the interface.
KnowhutImean?
PC|XB1
PC|XB1
-
- Posts: 8
- Joined: Wed Apr 20, 2022 11:51 pm
Re: Bourgault 3420-100 Paralink Hoe Drill Issue
Ok thanks, was hoping it was a quick fix but sounds more complicated.
Re: Bourgault 3420-100 Paralink Hoe Drill Issue
Not sure if it’s the same still but at one point courseplay wasn’t registering width correctly on certain implements until they were completely unfolded
Re: Bourgault 3420-100 Paralink Hoe Drill Issue
You can hover the mouse over the "8.5" and use the wheel to take it up. alot faster then clicking. But it's only certain implements it mostly just works fine.
Re: Bourgault 3420-100 Paralink Hoe Drill Issue
you can also just click on the incorrect width and type in your own. same if you use a manual heading, click and type. faster than clicking for me! didn't know about the mouse wheel scrolling thing, might be even faster.
6 posts
Page 1 of 1