Bourgault 3420-100 Paralink Hoe Drill Issue

Duck_Hunter
Posts: 6
Joined: Wed Apr 20, 2022 11:51 pm

Bourgault 3420-100 Paralink Hoe Drill Issue

Post by Duck_Hunter »

On the Bourgault 3420-100 Paralink Hoe Drill when using courseplay or guidance steering it says the width is 8.5 rather than 30.5. I have tried this using different tractors and verified it using the 3320 which works properly. Something in the programming of this mod is not correct. The air cart is 8.5, but I have tried it without the air cart not even bought yet, so that is not the issue. Currently I have to tap my mouse to get it up to 30.5, which is a pain as it only goes up by 0.1 for each click. Love using it though.
Earnest Pea
Posts: 576
Joined: Mon Jun 20, 2016 5:23 pm
Location: Canada

Re: Bourgault 3420-100 Paralink Hoe Drill Issue

Post by Earnest Pea »

Thats not the only piece of equipment that has a problem. The Case IH 3020 TerraFlex 25FT and the New Holland SuperFlex 25FT show up in guidance steering as 8.2 despite being 7.5. Its worse though. The AI treats them as 8.2 even thought they actually cut 7.5.

As for guidance steering: you can change the increment from 0.1 to 0.5 or 1.0 or possibly more using the controls built into the interface.
KnowhutImean?
PC|XB1
Duck_Hunter
Posts: 6
Joined: Wed Apr 20, 2022 11:51 pm

Re: Bourgault 3420-100 Paralink Hoe Drill Issue

Post by Duck_Hunter »

Ok thanks, was hoping it was a quick fix but sounds more complicated.
Mwal
Posts: 3270
Joined: Wed Aug 16, 2017 4:59 pm

Re: Bourgault 3420-100 Paralink Hoe Drill Issue

Post by Mwal »

Not sure if it’s the same still but at one point courseplay wasn’t registering width correctly on certain implements until they were completely unfolded
raran
Posts: 455
Joined: Wed Sep 02, 2020 8:52 am

Re: Bourgault 3420-100 Paralink Hoe Drill Issue

Post by raran »

You can hover the mouse over the "8.5" and use the wheel to take it up. alot faster then clicking. But it's only certain implements it mostly just works fine.
Bunky
Posts: 11
Joined: Fri Feb 11, 2022 2:52 am

Re: Bourgault 3420-100 Paralink Hoe Drill Issue

Post by Bunky »

you can also just click on the incorrect width and type in your own. same if you use a manual heading, click and type. faster than clicking for me! didn't know about the mouse wheel scrolling thing, might be even faster.
Post Reply