Kamaz 65116 - trailer attachers placement wrong

dbump · Post by **dbump** » Sat Jun 20, 2020 2:02 am

The rear trailer attacher (not the 5th wheel, the pin hitch) point is separated from the actual vehicle body by about a meter. Looking at the i3d in GE, I can move this object: "kamaz/attacers/trailerAttacherJointBack" to the correct location (needs to be dropped down a little bit as well, otherwise the trailer tongue displays through the top of the truck's hitch) and then trailers do attach to the correct visual spot on the truck, instead of looking like they are connected with an invisible tow bar.

The front attacher is also off, but by a small amount. It looks bad if you're outside the vehicle and look at it, but you might not otherwise notice. It's wrong in the opposite direction, being too close to the truck, so you can see the entire hole in the trailer tongue behind the pin.