Just a little wider?

[Boots]

Is there any way to make the pickup on balers and Forage Wagons just a little wider
The combine leaves a hump at the end of each strip and it would be handy if
the baler or forage wagon could pick it up on one go

[Timothy1176]

I have the same issue though it is a very minor annoyance because my OCD will not let me just leave those 2 little piles

[humbe]

If you're on PC, you could always edit the mod. Working width is not hard to find inside there..

I typically avoid the pile by just driving on, rather dumping some of the field on my way to where I'll be driving back the field... Or drive over it a second time.

[Boots]

I am on PC and I am the same my OCD will not let me leave without picking up the straw
If a job is worth doing it is worth doing well
I don't know what to look for in the xml file and to just increase the pickup a little to be able
to get it all in one pass

[StoneTheCrows]

In the combine, when you reach the end of a row, stop, and then backup a few metres. It spreads out that last dump of chaff so you don't get a pile at the end of the row.

[GothicKing13]

^^^ I was going to suggest the same thing, when you reach the end of the row, if you back up a little bit while the straw is still flowing out. Then it will keep it in a little tighter of a line. In doing this I don't have a problem with the balers/wagons picking up the rows, including the ends of them.

[MagicBoy]

I'd wager the OP is using AI helpers.

[StoneTheCrows]

I'd wager the OP is using AI helpers.

Ha ha. Well to be fair, I'm no farmer and I learned my technique from watching the AI.

[fenixguy]

Rake up the headlands with a windrower and do those first.

I just leave the excess myself. It's nice to have a bit left over in case you just need that tiny bit extra for the last bale. My OCD will allow me to leave straw/hay on the field, but it won't let me leave a baler with a partial bale in it.

[Boots]

Yes that's right it is the AI worker that leaves the pile and not only at the end of the field
The windrower is a good idea, did not think of that

[Phantoms]

I'd wager the OP is using AI helpers.

Don't the AI still stop and back up to spread the load in FS22? They do in FS19.

[hrvacx]

If you are on pc move the working width nodes in GE untill you get a proper working width.

[Noraf]

Just remember that any game files edits hampers mp.

And I'm sure we'll be getting a front mounted windrower again, with a center discharge

[wheelmansteve]

Run to one side a little, then back and grab the rest. AI leaves them when stopping for a full bin, too. (Still a 19'er.)

[Boots]

I just found this

How To Edit PickUp Widths Tutorial ! | Farming Simulator 22

https://www.youtube.com/watch?v=vu_wgJ1R9ts

Thanks for the information Elite Farming